Won't shift out of Park? The shift cable bushing problem
A shifter that moves but the transmission stays in gear, or a gear indicator that doesn't match, often points to a worn shift cable bushing.

You move the shift lever to Drive, the indicator says D, but the vehicle doesn’t move, or it starts in a gear it shouldn’t be in. Or the lever goes to Park but the key won’t come out. Before assuming the transmission has failed, check the shift cable and the small bushing at its end. It’s one of the cheapest “transmission problems” you can have.
How the shift linkage works
On most cable-shifted Mopar vehicles, a steel cable runs from the shifter in the cabin to a lever on the side of the transmission. A small plastic or rubber bushing pops onto a pin on that lever. Over time, heat and age make the bushing brittle. When it cracks or falls off, the cable is no longer connected to the transmission, even though the shifter still moves.
This is especially common on front-wheel-drive vehicles such as the Grand Caravan, Journey, Avenger and Chrysler 200, but cable bushings wear on many vehicles.
Symptoms
- Shifter moves freely, but the transmission stays in Park or another gear
- Gear indicator doesn’t match the actual gear
- Vehicle won’t start because the transmission isn’t truly in Park or Neutral
- Key won’t come out of the ignition (column-shift or key-interlock vehicles)
- Shifter feels sloppy or loose
Safety first: if the vehicle may not actually be in Park, set the parking brake and chock the wheels before you work around it.

How to check
- Set the parking brake firmly and chock the wheels.
- Open the hood (front-drive vehicles) or look under the vehicle (rear-drive) at the transmission shift lever.
- See whether the cable end is still attached to the lever pin, and inspect the bushing for cracks or missing pieces.
- With a helper moving the shifter, watch whether the transmission lever moves with the cable.
The fix
- Bushing only: if the cable and lever are fine, a replacement bushing is a quick, inexpensive repair. Make sure it snaps fully onto the pin.
- Full cable: if the cable is kinked, stretched, seized or its housing is damaged, replace the shift cable assembly. Cables are vehicle-specific and often come with new bushings and clips.
- Adjustment: after replacement, the cable must be adjusted so Park on the shifter is exactly Park at the transmission. Most cables have a locking adjuster at one end.
When it’s not the cable
If the cable is connected and moving the lever, but the transmission still won’t engage or shift, the problem may be internal or electrical: a range sensor, low fluid or a transmission fault. Check the fluid level first. Here are our guides to the 8-speed and the RFE transmissions.
Send us your VIN and we’ll match the cable or bushing kit for your vehicle.


