Troubleshooting

TIPM failures: no-starts, fuel pump and horn problems on 2007–2012 Mopars

The Totally Integrated Power Module controls power to everything from the fuel pump to the horn. How TIPM problems show up and how to diagnose them.

Under-hood fuse and relay box with blade fuses in a vehicle engine bay
Photo: Shixart1985 / CC BY 2.0

Strange electrical problems on a late-2000s Chrysler, Dodge, Jeep or Ram often trace back to one box under the hood: the TIPM, short for Totally Integrated Power Module. It’s the vehicle’s main fuse and relay center, and it also contains electronics that decide when to power many circuits.

Which vehicles?

TIPM complaints are most often associated with vehicles from roughly the 2007–2012 model years, including the Dodge Grand Caravan, Journey, Durango, Nitro, Dakota and Ram, the Chrysler Town & Country, and several Jeeps. Some were covered by recalls or extended warranties for specific symptoms. Check your VIN at nhtsa.gov/recalls before paying for a repair.

Typical symptoms

TIPM problems are notoriously random, which is what makes them frustrating:

  • Crank, no start, because the fuel pump doesn’t get power
  • Engine stalls while driving
  • Horn sounds by itself, or wipers run with the switch off
  • Fuel pump keeps running after the engine is turned off, draining the battery
  • Headlights, power windows or locks that work intermittently
  • Battery drains overnight

Why they fail

Inside the TIPM, relays and circuit-board traces carry high current. Heat cycling, internal relay wear and solder joint failures cause intermittent connections. On some vehicles, the fuel pump relay circuit in particular was a known failure point.

Silver Dodge Nitro SUV, one of the vehicles that uses a TIPM
The TIPM sits in the engine bay near the battery on most of these vehicles. Photo: IFCAR, Public domain

Diagnose before you replace

A TIPM is expensive, and other faults cause the same symptoms. Check these first:

  1. Battery and cables. Low voltage makes modules act strangely. Test the battery and inspect the cables and grounds. Our charging system guide explains how.
  2. Fuses. Check the specific fuse for the affected circuit.
  3. Fuel pump power at the pump. For a no-start, check whether the pump gets voltage when the key is turned on. If the TIPM supplies power and the pump doesn’t run, the pump is the suspect. See our fuel pump guide.
  4. Scan for codes in all modules, not only the engine computer.
  5. Corrosion. Water intrusion into the TIPM connectors causes many “TIPM failures.”

Repair options

  • Replace the TIPM with the correct part for your vehicle. TIPMs are vehicle-specific and often need to be programmed or configured to the VIN with a dealer-level scan tool.
  • External fuel pump relay bypass: some vehicles have an official repair kit that moves the fuel pump relay outside the TIPM. Ask your dealer whether one applies to your vehicle.

Ordering

TIPM part numbers depend on options, so a used unit “from the same model” may not work. Dakota and Nitro owners will find more model-specific advice in our Dakota and Nitro guide, and minivan owners in the Grand Caravan guide. Send us your VIN and we’ll identify the correct module and tell you whether it needs programming. Other electrical problems? Our electrical parts are listed by exact Mopar number.