TorqueFlite 8-speed fluid and filter service: what owners should know
The 8-speed automatic in Chargers, Challengers, Durangos and Ram 1500s is often called 'lifetime fill.' Here's why many owners service it anyway, and how.

Since 2013, most rear-drive and four-wheel-drive Mopar vehicles have used an 8-speed automatic branded TorqueFlite. It’s built under license from the ZF 8HP design. You’ll find it in the Ram 1500 (2013+), Charger and Challenger (2015+ on most trims), Durango, Chrysler 300, and Jeep Grand Cherokee and Wrangler. It’s a strong, smooth transmission, but it’s sensitive to fluid condition and fluid level.
Is it really “lifetime” fluid?
Many owner’s manuals list no routine fluid change for normal driving, or only list one for severe service. In practice:
- Towing, hauling, hot climates, track use and lots of stop-and-go all count as severe service for most owners.
- Fluid breaks down with heat. After 60,000–100,000 miles of hard use, a service often improves shift quality.
- There’s no dipstick, so fluid problems go unnoticed until they show up as shift complaints.
A fluid and filter service is relatively inexpensive compared with a transmission repair. Many specialists recommend it in the 60,000–100,000-mile range, sooner for towing.
What the service involves
On these transmissions, the filter is built into the plastic oil pan, so the pan and filter are replaced as one assembly with a new seal. A typical service:
- Drain the fluid (some pans have a drain plug).
- Remove and replace the pan/filter assembly, torquing the bolts to spec. Over-tightening a plastic pan cracks it.
- Refill through the fill plug on the side of the case with the correct fluid.
- Set the level at the specified fluid temperature with the engine running, using a scan tool to read the temperature. The level is checked at the fill plug.
Step 4 is where DIY jobs go wrong. Overfilling or underfilling by even a small amount can cause harsh shifts or slipping. If you don’t have a scan tool that reads transmission temperature, this is a job for a shop.

Use the correct fluid
The 8-speed requires a specific ATF. Use the fluid named in your manual: Mopar’s 8 & 9-speed ATF, or a ZF-approved equivalent for the 8HP family. Don’t use generic multi-vehicle ATF. Friction characteristics matter for shift quality and torque converter clutch behavior.
Symptoms that deserve attention
- Harsh 1–2 or 2–3 shifts, or a “bang” into gear
- Shudder at steady speed around 30–50 mph (often torque converter clutch related)
- Delayed engagement into Drive or Reverse
- Fluid seeping from the pan seal or the electrical connector
A software update fixes some shift-quality complaints, so ask a dealer to check for updates before replacing parts.
Parts we stock for the job
We list pan and filter kits, seals and related parts by exact part number. Browse automatic transmission filters or send us your VIN and we’ll confirm the right kit.
Own an older Ram with an RFE transmission? See our RFE transmission service guide instead.


